So, we’ve tested a few more sophisticated battery–monitor gauges that also measure current draw in amps, along with other parameters, and report that info in real time to help you manage power and its use. Some of these devices can be programmed with a battery’s amp capacity and keep track of capacity used and remaining. In the Box: The kit comes with a gauge, a locking collar, a 19.6-foot wiring umbilical cord with pre-installed connectors for the gauge, button, battery system and other VDO gauges, and a sensor shunt that clamps to the negative battery terminal to measure amperage in and out. Separate IBM kits are available for 12- and 24-volt onboard DC systems. Installation: It was a complicated installation however, the instructions were clear and easy to follow. With a few missteps, the gauge took about 40 minutes to connect and make operational. With one practice run-we recommend doing it on a bench-the actual install time could be minimized, with the exception of drilling the gauge and toggle-button holes, and pulling the wires. For a step-by-step explanation of this installation, see our article “ Installing a Battery Monitoring System”. What We Saw: Once connected, the gauge displayed voltage on our 12-volt bank. It was near 12 volts and registered a large fraction of full. We connected an LED strip light to the system and toggled the gauge to display amperage flow, and read the flow to be about 1 amp, as expected for the light. We connected a charger to the battery, and the red arrow pointing upward to depict outflow changed to the green inflow arrow pointing downward and registered 8 amps-normal for our charger. Veratron’s VL Flex Marine app is designed to calibrate all Veratron gauges via Bluetooth. The connection and setup are easy by following the prompts in the app. This device fits in a 2 1/ 16-inch hole and has a threaded plastic locking collar. The meter display takes up half the gauge’s face, and built-in toggle buttons switch functions and calibrate the gauge to the battery’s capacity, type and voltage. The gauge’s memory records battery events, such as high or low voltage, and a low-voltage alarm can be configured to protect against stranding. The Xantrex Link Pro has an Ethernet cable port for connecting the device to Xantrex chargers and inverters. It is designed for flooded-cell, gel and AGM batteries. In the Box: The gauge, locking collar, 25-foot cable and sensor shunt are all included in the box, with directions for wiring either a 12- or 24-volt system. Power lines are fused, and fuses are included. Installation: Connections on the Xantrex charger are analog, and its 25-plus-foot-long connection cable had six color-coded wires inside. Each colored wire had to be inserted into the connector bar on the back of the gauge and, following the color chart provided, connected to the shunt. Battery connections to the shunt were also easy following the color-coded wiring diagram. What We Saw: The monochrome LCD gauge was simple, but fonts were bold. #MARINE BATTERY STATUS MONITOR INSTALL#.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |